Ultipleat® High Flow 1 Micron Element

The 1 µm Ultipleat® High Flow Element is a large diameter, coreless, single open ended, pleated cartridge with an inside to outside flow pattern. The filter’s unique, crescent-shaped pleat geometry, combined with its large 6.3 inch (16 cm) diameter allows you to use fewer filters to remove fine particles and cysts in high flow applications.

• High flow rates per element
• Low cost of installation and filtration
• Fewer elements per change out
• 1 µm absolute* filtration
• Polyethersulfone media provides greater than 3 log reduction of Giardia oocysts and Cryptosporidium
• Inside to outside flow configuration retains all particulate matter inside the element
• Coreless, all plastic construction to minimize waste disposal
• U-cup element seal ensures high level removal efficiencies
  
  

  * Particle Removal Rating 

   
  
  
  Crescent-Shaped Pleat Geometry
  
  

Performance Specifications

Water flow rate
20" length – 68 gpm/psid (257 lpm/70 mbar)
40" length – 135 gpm/psid (511 lpm/70 mbar)
60" length – 204 gpm/psid (772 lpm/70 mbar)

Maximum forward differential pressure
50 psid @ 180°F (3.44 bar @ 82°C)

Maximum operating temperature
180°F (82°C)

Sanitization

• Can be sanitized with hot water (185°-194°F/85°-90°C) for a maximum of 100 cycles
     (1 cycle = 10 minutes) without compromising the removal efficiency of the filter.
• Peracetic acid, chlorinated alkaline products and other sanitization chemicals may be used.
     Contact Pall for recommended procedures.
  
  

  Product Specifications

  
               
  Materials of Construction
  

  Filter Media:	1 µm polyethersulfone
  Outer Sleeve and End Caps:	Polypropylene
  Drainage and Wrap:	Polypropylene
  Wrap Adhesive:	Polyolefin hot melt
  Filter Seal:	FDA compliant ethylene propylene

  
  Dimensions
  

  Diameter:	6.3" (16 cm)
  Length:	20", 40", 60" (51 cm, 102 cm, 152 cm)

  
  Other Ultipleat High Flow Elements
  Ultipleat High Flow elements are available in other filter
  media with absolute ratings of 2, 4.5, 10, 20, 40 and
  100 µm. Contact Pall for more information.
  
  Housing Design
  A single element, sanitary designed housing is available
  for use with the 1 µm Ultipleat High Flow element. 
  Industrial style housings are also available.
  Contact Pall for more information.
  
   
   
  

 

• Incoming water filtration
• Barrier to cysts and oocysts
• Prefilter for bottled water sterilizing filters
• Food and beverage processes
  

1 µm Ultipleat High Flow

Product Part Number:  HFU6  CAS010JUW

Code	Length
20	20" (51 cm)
40	40" (102 cm)
60	60" (152 cm)

Ultipleat® High Flow Filter Systems: Payback Calculator